Siemens SIMATIC S5 Manual page 297

Troubleshooting
80:
81: PG job list is full*)
82: job not permitted *)
83: statement saved
84: axis active ==> entry not possible
85: PC job list is full
86: motor waiting for external start *)
87: speed range exceeded
88: status after power down on module
89:
8B:
8D: data block does not exist
8E: wrong or no machine data
8F: error in machine data
90: PG is offline
91: overwrite machine data?
92: max. number of programs reached
93: data block does not exist
94: overwrite machining program?
95: automatic not permitted
96: processing more than one reach. prog. not permitted *)
97: traversing range exceeded
98: not enough space for machining program
99 start limit switch tripped
9A: end limit switch tripped
96: external STOP received
9C: software start limit switch tripped
9D: soflware end limit switch tripped
9E: mode not permitted in teach-in 9
9F:
AO:
Al: cycle time exceeded
A2: pulse generator defect ~
A3: error at start of statement
A5: G function not permitted
A6: closed loop only as outer loop
A8: X function wrong
AA: traversing distance too long
AB: traversing speed too high
AC: error at end of statement
AD: program end before loop end
AE: illegal mode on this axis*)
AF: change of direction illegal after flying change
BO: machining program error
possible causes of module errors marked
with
are listed from page 35 onwards.
7 - 3 0
- - - - - -
I
)
)
Siemens AG°C79000-B8576 -C707-Ol