Siemens SIMATIC S5 Manual page 185

Test
Mode:
Here, the required mode and selected axis are entered. You can select the mode from the
mode table with the HELP key <F7>. After you have entered the mode number (right-
justified), the corresponding text is displayed to the right of the mode number. Modes
1,.,17 are permitted. If a different number is specified, you branch automatically to the
mode table, Depending on the selected mode, the function keys <F2>... cF6> have
different functions,
Program:
You can only write to this input field in modes 8 (AUTOMATIC), 9 (AUTOMATIC S1 NGLE
STATEMENT) and 10 (TEACH-1 N ON). In these cases, you must enter the machining pro-
gram number,
Distance:
You can only write to the distance input field in modes 6 (INCREMENTAL ABSOLUTE), 7
(INCREMENTAL RELATIVE), 12 (ZERO OFFS~ ABSOLUTE), 13 (ZERO OFFSEl_
or coordinate in the selected dimension.
Speed:
In this field, you can enter the start speed within the range 1,,.65000, Value O selects the
value stored in the machine data. If you enter a value greater than the meximum speed,
the value of the maximum speed is set.
Significance of the function keys
With <Fl >, you can switch between the actual value display mode and the mode
change function. In the actual value display mode the values actual value, distance to
go, aux, function and the displayed axis attributes of the selected axis are displayed
and continuously updated. If you select the mode change function the mode and corre-
sponding parameters can be changed.
"START" is only permitted in modes 4..,6,8...12 and 14...17.
"STOP" is only permitted in modes 1,2 and 6...9.
<F4>: The command "FORWARD" is permitted in modes 12,7, 13 and 15. If a rotary axis is
selected as the axis type, the "FORWARD'
The command "REVERSE" is permitted in modes 12,7, 13 and 15. If a rotary axis is
<F5>:
selected as the axis type, the "REVERSE" command is also permitted in mode 6.
The function of the "ENTER" key depends on the mode.
statement of an automatic program.
In the "AUTOMATIC" mode, the "ENTER" key is used to acknowledge a programmed
halt (MOO).
I nthe "AUTOMATIC" and "AUTOMATIC SI NGLE STATEMENT" modes, this key
continues an interrupted machining program.
If the teach-in mode is active and the axis status is "finished", the "ENTER" key is
used to save a statement.
Providing the cursor is located in the input field "mode", the HELP key <F7> can be
used to branch to the mode table. From this table you can select a mode and return to
the mode display with <F6> (ENTER).
The EXIT key returns you to the test axis selection display. The header remains un-
changed.
5 - 4 8
i
command is also permitted in mode 6.