Siemens SIMATIC S5 Manual page 146

Remember
If your programmer has one floppy disk drive, the hard disk has the logical name "B". The
operating system displays the prompt "B>".
Next, the programs on the pCp/M diskette must be copied to the hard disk, as follows:
.
Start the PG by turning on the power or using the keyswitch
> A> PIP <CR>
<CR>
> *B: =*.*
If PC P/M was supplied on more than one diskette, the programs from the other diskette should
also be copied to the hard disk:
Next PCP/M diskette in drive A:
> *B: =*.* <CR>
After copying the last diskette, press <CR>, to complete the copying program "PIP". N
all the PCP/M system programs are on the hard disk, this can be selected as the default drive:
A> B: <CR>
The operating system now searches for all programs on the hard disk, unless a floppy disk is
specified explicitly.
To avoid the programs being deleted accidentally, and to make them accessible from all user
areas, assign the "read-only" (RO) and "system" (SYS) attributes using the "SET' utility as follows:
B> SET B:*.WIRO SYS] <CR>
Installing COM246
The following description assumes that S5-DOS is installed on your PG. If this is not the case,
please read the section "installing PC P/M".
To install COM247 on the hard disk, you simply copy the file S5PDC1 OX.CMD on the supplied
Start the PG by turning on the power or using the keyswitch without a diskette in the
drive
B> PIP B:= A: S5PEC1OX.CMI3 <CR>
>
B> SET B: S5PECIOX.CMD IRO SYS] <CR>
>
Getting Started
that
OW
5 - 9