Advertisement
Installing the Camera
ATTENTION
- Test the camera prior to selecting a permanent
mounting location by temporarily connecting the camera(s) and
cables to the DVR.
1. Use the included Dome Cover Key or your finger
to push in the button on the camera base while
pulling the dome cover up.
2. Locate the white latch on camera base (near LOCK
and UNLOCK labels). Push the latch outward and
hold in place.
Push
outward
3. Twist the black back plate
counterclockwise to
detach it from the camera.
Release the latch.
4. OPTIONAL: Punch out the disc
in the centre of the black back
plate to run cables through
the mounting surface.
Punch out and
run cables
through here
5. Mark the position of the 3
holes in the black back plate.
Drill holes where marked.
6. OPTIONAL: Insert drywall anchors as needed.
7. Use the included screws to attach the black back
plate to the mounting surface. Make sure the
CAMERA FRONT label points away from the
mounting surface.
8. Place the camera base over the black back plate
and turn counterclockwise to lock in place.
9. Use a flat-head screwdriver to slightly loosen the
ZOOM and FOCUS knobs. Move knobs left and
right to adjust zoom and focus. Tighten knobs when
finished.
ZOOM
10. Adjust the position of the camera by rotating the
black camera module (rotates 360° before it is
stopped).
Press to
open housing
11. Use a Philips screwdriver to loosen the screws on
either side of the camera module. Tilt the top of the
module to adjust the viewing angle. Tighten screws
when finished.
Loosen screws
on both sides
to tilt
12. Replace the dome cover so the arrow on the dome
cover points toward the button on the camera base.
Setting up the Camera
1. Connect the BNC connector of the camera to the
video cable.
2. DC Power—Power Adapter: Connect a 12V DC
Power Adapter (not included) to the camera. Plug
the Power Adapter into a local power outlet.
• DC Power—Power Pigtail (not included): Connect
a Power Pigtail to the camera. Connect the
terminating wires of the cable directly to the DC
power source.
NOTE: For pigtail connection with 12V DC, make sure to
check polarity specifications on the power adapter.
Camera Specifications
Image Sensor
Video Format
Effective Pixels
Horizontal Resolution
FOCUS
Scan System
Sync System
S / N Ratio
Iris
AES Shutter Speed
Min. Illumination
Video Output
Lens Focal Length / Type
FOV (Diagonal)
Termination
IR Range / Qty.
NOTE: Make sure IR
Power Requirement
LED's are clear from
camera housing when
Power Consumption
installed. If IR LED's are
blocked, nighttime image
Operating Temp. Range
may appear cloudy.
Environmental Rating
Dimensions
Weight (including stand)
Dimensions
128mm / 5.0"
1/3" 960H Image Sensor
PAL
H: 960 V: 480
700 TVL
2:1 Interlace
Internal
48dB (AGC Off)
AES
1/50 ~ 1/25,000 sec.
0.3 Lux without IR LED
0 Lux with IR LED
Composite 1.0Vpp @ 75ohm
2.8–12mm
F2.0
/ Varifocal
28° ~ 94°
Video: BNC Female
65ft /
20m; 17 IR LED's
12V DC ± 10%
12V: 265mA MAX with IR LED
14° ~ 122°F / –10° ~ 50°C
Indoor Only
Diameter: 5.0" (128mm)
Height: 3.6" (91mm)
0.6lbs / 0.3kg
91mm /
3.6"
Advertisement
