Table of Contents
Advertisement
Table of Contents
4.2 Upgrading with DNA
How to perform the firmware upgrade
Run DNA and perform the firmware upgrade according to instructions in the DNA User Manual. To
download the manual, find the steps here.
4.3 Upgrading from the Camera's Web Interface
How to perform the firmware upgrade
The order in which the firmware upgrade is to be done is important and is covered in section 4.1 above.
Section 4.3 details the specific locations in the web UI that are involved in the upgrade process.
To upgrade the camera's firmware
1. From the Setup tab in the unit's web interface, select System > Basic
Configuration > Firmware.
2. To load the camera's firmware, under Firmware Upload, Click Browse to locate the
firmware file.
3. Select the file. The file name is displayed (for example, CM-6308-P1-I_20190226.bin).
4. Click Upgrade. The upgrade process takes about three minutes. After the
firmware has upgraded successfully, the camera reboots. The Rebooting
Complete dialog box opens.
To upgrade the FPGA firmware
1. From the Setup tab in the unit's web interface, select System > Basic
Configuration > Firmware.
2. under FPGA Firmware Upload click Browse to locate the upgrade file.
3. Select the file. The file name is displayed (for example,
flirpano_a7_29171533_cs.bit).
4. Click Upgrade. The upgrade process takes about three minutes. After the firmware has
upgraded successfully, the camera reboots. The Rebooting Complete dialog box opens.
viii
CM-6308-P1-I FW v.20190226 Release Notes
April 2, 2019
Advertisement
Table of Contents
