Mirroring-Group Monitor-Port (Interface View) - H3C S5830V2 Series Command Reference Manual

Examples
# Create remote source group 1, and configure port Ten-GigabitEthernet 1/0/1 as its egress port in
system view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress ten-gigabitethernet 1/0/1
# Create remote source group 2, and configure port Ten-GigabitEthernet 1/0/2 as its egress port in
interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface ten-gigabitethernet 1/0/2
[Sysname-Ten-GigabitEthernet1/0/2] mirroring-group 2 monitor-egress
Related commands
mirroring-group

mirroring-group monitor-port (interface view)

Use the mirroring-group monitor-port command to configure the port as the monitor port for a mirroring
group.
Use the undo mirroring-group monitor-port command to remove the monitor port of a mirroring group.
Syntax
mirroring-group group-id monitor-port
undo mirroring-group group-id monitor-port
Default
No monitor port is configured for a mirroring group.
Views
Interface view
Predefined user roles
network-admin
Parameters
group-id: Number of the mirroring group. The mirroring group specified by group-id must already exist.
The value ranges from 1 to 4.
Usage guidelines
You can configure the monitor port only for a local mirroring group or remote destination group but not
for a remote source group.
Do not enable the spanning tree feature on the monitor port.
When a Layer 2 aggregate interface is configured as the monitor port, do not configure its member ports
as source ports.
Use a monitor port only for port mirroring to make sure that the data monitoring device receives and
analyzes only the mirrored traffic rather than a mix of mirrored traffic and normally forwarded traffic.
Do not configure a port of an existing mirroring group as a monitor port.
123