Info-Center Source - H3C S5830V2 Series Command Reference Manual

Views
System view
Predefined user roles
network-admin
Parameters
interface-type interface-number: Specifies the egress interface for logs by the interface type and interface
number.
Usage guidelines
After the source IP address of logs is specified, no matter which physical interface is used to output the
logs, the source IP address of the logs is the primary IP address of the specified interface.
The info-center loghost source command takes effect only after the information center is enabled with the
info-center enable command.
The IP address of the specified source interface must be configured; otherwise, although the info-center
loghost source command can be configured successfully, the log host will not receive any log.
Examples
# Specify the IP address of interface loopback 0 as the source IP address of logs.
<Sysname> system-view
[Sysname] interface loopback 0
[Sysname-LoopBack0] ip address 2.2.2.2 32
[Sysname-LoopBack0] quit
[Sysname] info-center loghost source loopback 0

info-center source

Use the info-center source command to specify the output rules of the logs.
Use the undo info-center source command to restore the default.
Syntax
info-center source { module-name | default } { console | logbuffer | logfile | loghost | monitor } { deny
| level severity }
undo info-center source { module-name | default } { console | logbuffer | logfile | loghost | monitor }
Default
The following table lists the output rules for the logs:
Output
destinatio
n
Console
Monitor
terminal
Log
System
informati
Enabled/
on source
disabled
All
supported Enabled
modules
All
supported Enabled
modules
Security log
Enabled/
Level
disabled
Debug Disabled
Debug Disabled
81
Hidden log
Enabled/
Level
disabled
N/A Disabled
N/A Disabled
Level
N/A
N/A