Snmp-Agent Usm-User { V1 | V2C - H3C S5830V2 Series Command Reference Manual
Network management and monitoring
Hide thumbs
Also See for S5830V2 Series:
- Security configuration manual (332 pages) ,
- Configuration manual (318 pages) ,
- Command reference manual (301 pages)
Table of Contents
Advertisement
Examples
# Configure the IP address of Vlan-interface1 as the source address of SNMP notifications.
<Sysname> system-view
[Sysname] snmp-agent trap source Vlan-interface1
Related commands
display snmp-agent community
•
snmp-agent target-host
•
snmp-agent trap enable
•
snmp-agent usm-user { v1 | v2c }
Use the snmp-agent usm-user { v1 | v2c } command to add a user to an SNMPv1 or SNMPv2c group.
Use the undo snmp-agent usm-user { v1 | v2c } command to delete a user from an SNMPv1 or
SNMPv2c group.
Syntax
snmp-agent usm-user { v1 | v2c } user-name group-name [ acl acl-number ]
undo snmp-agent usm-user { v1 | v2c } user-name group-name
Default
No SNMP users have been configured.
Views
System view
Predefined user roles
network-admin
Parameters
v1: Specifies SNMPv1.
v2c: Specifies SNMPv2c.
user-name: Specifies an SNMP username, a case-sensitive string of 1 to 32 characters.
group-name: Specifies an SNMPv1 or SNMPv2c group name, a case-sensitive string of 1 to 32
characters. The group can be one that has been created or not. If the group has not been created, the
user takes effect after you create the group.
acl acl-number: Specifies a basic ACL to filter NMSs by source IP address. The acl-number argument
represents a basic ACL number in the range of 2000 to 2999. Only the NMSs with the IP addresses
permitted in the ACL can use the specified username (community name) to access the SNMP agent.
Usage guidelines
When you create an SNMPv1 or SNMPv2c user, the system automatically creates a community that has
the same name as the SNMPv1 or SNMPv2c username. This community has the same access right as the
SNMPv1 or SNMPv2c group. To display the SNMPv1 and SNMPv2c communities created in this way,
use the display snmp-agent community command.
To change the access right of the SNMPv1 or SNMPv2c user, use the snmp-agent community command
or the snmp-agent group { v1 | v2c } command. If the snmp-agent community command is used, the
SNMPv1 or SNMPv2c is removed from the SNMP group.
113
Advertisement
Table of Contents
