Table of Contents
Advertisement
EDITION 10/2005
OPERATING MANUAL
5.4.2
ADJUST THE SPRAY ANGLE WITH FLAT JET NOZZLE
The spray pattern can be adjusted to suit the object being sprayed using the fan air regula-
tor.
Other nozzle sizes can be used to obtain larger or smaller spraying patterns.
View A
Backsight (Seen from the spraying direction)
wide spray angle = minimale
shaping air adjustment
Fan air regulator
narrow spray angle = maximale shap-
ing air adjustment
5.4.3
FITTING OR CHANGING ROUND JET NOZZLE
1. Switch off control unit.
2. Relieve spray gun and unit pressure.
3. Replace paint with cleaning solvent
and
4. Thoroughly fl ush spray gun: always
point spray gun downwards while
fl ushing
5. Relieve spray gun and unit pressure.
6. Dry material hose and gun by blowing
through with dry and clean air.
7. Unscrew the tip nut (B) by hand and
remove it.
8. Remove the nozzle body (C) and the
nozzle insert Supra (A).
9. Unscrew nozzle insert Supra (A) with
nozzle spanner (I) from the nozzle body
(C) .
10. Re-assemble in reverse order.
Note
To protect the electrode-needle replace
the cap (D) when thr gun is not in use.
PART NO. DOC0388891
GM 2800EA
A
28
Advertisement
Table of Contents
