Most of operations of planned maintenance may be carried out by the driver or other user of the tractor. In
case you do not have sufficient technical equipment, let the difficult operations carried out by a specialised
repair shop.
All works, connected with cleaning, lubrication and adjustments of the tractor or coupled
mechanisms may only be carried out after stopping of the engine and other movable components
except checks of brakes, recharging and hydraulic system.
Front bonnet opening
To open the hood:
Unlock the hood by pushing, using a suitable tool (e.g.
a screwdriver), on the rod (1) in the direction of the arrow.
The rod is located in the hole on the left side of the hood.
Grasp the hood and lift it.
In the raised position, the hood is locked by the gas-liquid
safety stop.
To close the hood:
Pull the hood down using the strap and snap it down until
the hood lock engages.
When the front hood is slammed shut, the
headlight bulbs filaments located in the front hood
may be damaged.
Checking oil levels in engine
Check daily before starting the operation with the tractor
standing horizontally. Engine oil dipstick (1) and filling hole
(2) are placed on the rights side of the engine. Unscrew
the dipstick (1), wipe off with a cloth and screw back in.
When you unscrew the dipstick again, the level must not
drop below the bottom gauge. If necessary, refill oil by
a filling hole (2).
Draining oil from engine
1. unscrew the drain plug (1), best immediately after
terminating the drive or after heating the engine to working
temperature
2. drain oil
3. clean the drain plug
4. screw the drain plug (1) back in
MAINTENANCE INSTRUCTIONS
PCLPN073
PCLPN074
PCLPN075
163