IDTECK STAR ICON100 User Manual page 39

STAR ICON100
OUTPUT TEST
OUTPUT 5
Press any key . . .
13.4.4 LCD TEST
LCD TEST
Last Update
Press any key . . .
13.4.5 Keypad TEST
KEYPAD TEST
0123456789ABCDEF
13.4.6 Readers TEST
READER TEST
ICON100-20011128
To test the output performances, press <ENT> key. If the output
performance has no problems, the test will proceed as follows:
First, the green LED blinks twice as the relay is being shorted and
opened twice. The relay makes a clicking sound as it runs. Second, the
yellow LED blinks twice as the relay is being shorted and opened twice.
The relay makes a clicking sound as it works. Third, the LCD changes its
figure, 'ON, OFF, ON, OFF'. Fourth, the buzzer beeps twice.
Note: The LCD provides no message to indicate if the test has finished
successfully
This figure means that the test has finished. Press any key to return to
the setup menu. Use <4> or <6> key to scroll to perform other tests.
To test the performance of the LCD, press <ENT> key. As the test
proceeds several characters will move quickly from right to left.
This means the test has finished. Press any key to return to the setup
menu. Use <4> key and <6> key for testing other performances.
To test the performance of the keypad, press <ENT> key.
When operating normally, pressing the keys on the keypad will display
the corresponding letter on the LCD.
Note: For function keys, the letters A, B, C, D, E and F will refer to the
<F1>,
<F2>, <F3>, <F4>, <ESC> and <ENT>key, respectively.
To test the performance of the reader, press <ENT> key.
39
ID TECK
ACCESS CONTROLLER