IDTECK STAR ICON100 User Manual page 27

STAR ICON100
13.2.1 Registering and Changing Time Schedule
TIME SCHEDULE
or ESC
TIME SCHEDULE
T/S : 01 HOL : 1
00:00 - 00:00
☞. Possible values for time scheduling
1) Time schedule number : 01 ~ 10 (Needed when IDs are registered)
2) A day of the week
3) Index
ICON100-20011128
'ENT'
NO
You may program time schedules to grant and restrict access for each
user. There can be up to ten different schedules. A minimum of one
schedule must be defined. If only one schedule is programmed the most
common setting allows access for all users 24 hours / day. A time schedule
can be programmed for each day of the week and holidays (see 13.2.2
page 28), and five shifts can be defined for each day. To set time
schedules, press <ENT> key from this menu.
If you want to set time schedules, press <ENT> key when this figure is
displayed.
Press <2> key or <8> key to adjust the Time Schedule (T/S) number (1-
10) and the day of the week (Mon-Sun and 'HOL'). Define which shift of the
day (1-5), using the <4> key and <6> key. 'HOL' refers to specific holidays
you will register(see 13.2.2 page 28). Press <ENT> key, and the cursor will
blink, then enter the beginning time of the period, in the form of hour(2-
digit):minute(2-digit) and the ending time in the same form. Then the lower
line will indicate the defined period. For more schedules, repeat the
process.
To end time scheduling, press <ESC> key.
: MON, TUE, WED, THU, FRI, SAT, SUN, HOL
: 1 ~ 5(referred to the five periods of time of a day)
DISPLAY CURRENT T/S
SELECT T/S NUMBER AND INDEX
(USE '2','8','4','6' KEY)
'ENT'
ENTER T/S(8 DIGIT)
(START TIME(hh:mm)-END TIME(hh:mm))
NEXT?
27
ID TECK
ACCESS CONTROLLER
YES or Error