IDTECK STAR ICON100 User Manual page 36

STAR ICON100
13.3.5 Setting Possible Registration ID Count
ID COUNT
ID COUNT
500
ENTER ID COUNT
[_ _ _ _ _]
EVENT MEMORY
NOT EMPTY !!!
ID TOTAL COUNT
Wrong !!!
ICON100-20011128
EVENT MEMORY
'ENT'
EMPTY ?
NO
DISPLAY "EVENT MEMORY"
NOT EMPTY
DISPLAY "INVALID COUNT"
DISPLAY "ID TOTAL COUNT"
" WRONG !!!"
You should choose which possible registration ID count is to be applied.
The default count is "500"( up to 7,250 events can be stored off-line. ).
If necessary, press <ENT> key.
This figure appears When you press the <ENT>key( and event memory
is empty or not used.). You are to enter a new upper limit of ID registration
which must be a multiple of 500.
You'll see this message when the event memory have been used and
it's not empty. You can try again after uploading the data to the host or
deleting them, using the setup mode F1.
This message will show when the entered number is less than the total
number of the registered IDs. If you want to delete some of the IDs and
reduce the possible registration ID count, clear the event memory, using
the setup mode F1 first and try again from the beginning.
YES
NO
NO
36
ID TECK
ACCESS CONTROLLER
ENTER NO. (3 ~ 5 digit)
ID COUNT VALID ?
YES
REGISTERED ID COUNT
< ENTER NO. ?
YES
COMPLETE