IDTECK STAR ICON100 User Manual page 38

STAR ICON100
13.4.1 VERSION
VERSION
F/W : Rev. 2.5
13.4.2 SRAM TEST
SRAM TEST
Memory fail !!! 0
RAM testing...
RAM test pass ! ! !
Press any key . . .
13.4.3 Outputs TEST
OUTPUT TEST
ANY KEY
ICON100-20011128
The version of the controller's firmware is displayed on the LCD.
Press <4> or <6> key to look for other menus of setup menu F4.
To test the memory, press <ENT> key.
This message would indicate the SRAM has problems. In this event,
contact technical support. Press any key to return to the setup menu. Use
<4> key and <6> key for testing other performances.
This message appears when the SRAM is operating normally.
Press any key to return to the setup menu. Use <4> key and <6> key for
testing other performances.
RELAY 1 TEST
ENT
(ACTIVATED TWO TIMES)
RELAY 2 TEST
(ACTIVATED TWO TIMES)
TTL OUTPUT 1 TEST
(ACTIVATED TWO TIMES)
TTL OUTPUT 2 TEST
(ACTIVATED TWO TIMES)
BUZZER TEST
(ACTIVATED TWO TIMES)
OUTPUT TEST END
38
ID TECK
ACCESS CONTROLLER
This test is applicable to Relay1
and green LED.
This test is applicable to Relay2
and yellow LED.
This test is applicable to TTL1
output.
This test is applicable to TTL2
output.
This test is applicable to Buzzer
output.