IDTECK STAR ICON100 User Manual page 24

STAR ICON100
13.1.9 Clearing Card IDs
CARD ID CLEAR
Card ID Clear
1 - Yes , 0 - No
13.1.10 Clearing Time Schedule
TIME SCHE CLEAR
Time Sche Clear
1 - Yes , 0 - No
13.1.11 Selecting ID Input mode
RF_PIN_INPUT
ENABLE
RF_PIN_INPUT
-->DISABLE
13.1.12 Selecting Event memory USE or NOT USE
EVENT MEMORY
NOT USE
EVENT MEMORY
-->USE
ICON100-20011128
Used to erase ALL the card ID data. stored in the device.
If you want to do so, press <ENT> key.
When this figure appears on the LCD, press <1> key to clear and <0>
key to cancel the operation, then the LCD automatically returns to the start
menu.
CAUTION: Be careful in using this operation, or you may lose
important data.
Used to erase ALL the time schedules. If you want to do so, press
<ENT> key. CAUTION: This function will erase ALL programmed time
schedules.
When this figure appears on the LCD, press <1> key to clear and <0>
key to cancel the operation, then the LCD automatically returns to the start
menu.
You can enable PIN(card number) to be input through the keypad, so
that someone who doesn't carry RF cards with him can access the door.
When it is disabled, accessing the door by keypad will be denied.
The display shows the current mode. Press <ENT> key to toggle the
mode.
You can select whether the Stand Alone is used or not. The lower line
on the LCD indicates the current mode. Press <4> or <6> to toggle the
mode, from NOT USE to USE or the reverse, and finish selecting by
pressing <ENT> key.
Note: If you select NOT USE, then system will not display event full
message.
24
ID TECK
ACCESS CONTROLLER