Inserting Paper Roll And Ribbon Cartridge; Sartocheck ® 4 Multiunit - Sartorius Sartocheck 4 plus Operating Instructions Manual

5.5.1 Inserting Paper Roll
Ribbon Cartridge
®
5.5.2 Sartocheck 4 Bag tester MultiUnit
To insert or change the paper roll, lift the cover off the paper feed. Pull the feed
mechanism out of the assembly and push the cover to the left and lift it out
of its attachments. Now lift the paper feed mechanism out of the Sartocheck
Bag tester housing.
Insert a new paper roll into the paper slot and slide the paper feed mechanism back
into the housing. Thread the end of the paper through the slot of the paper feed.
Make a final check to ensure that the feed mechanism is locked in place.
Close the printer cover and secure the splashguard. Check to make sure that the
splashguard is locked in place.
To change the ribbon cartridge (when the feed mechanism is pulled outwards)
lift the previously installed cartridge out of the paper feed and insert a new one.
Apply slight pressure to lock the cartridge in.
®
Sartocheck 4 Bag tester MultiUnits are connected to the Sartocheck
®
tester or to the Sartocheck 4 plus Bag tester via the serial port TU connection ports.
Different ways of connecting are shown below in Fig. 5-11 to 5-14. Two possible
methods of connection are shown below in Fig. 5-13 and Fig. 5-14. The location
®
of the Sartocheck 4 Bag tester MultiUnits, relative to the Sartocheck
tester or to the Sartocheck ® 4 plus Bag tester, will determine which method is best
suited for the application.
Fig. 5-14 | Serial connection to a Bag tester
®
4 plus
®
4 plus Filter
®
4 plus Filter
Installation 21