Table of Contents
Advertisement
7.2. DISASSEMBLING THE EPROM
Figure 7.2-1
Figure 7.2-2
Page 7.2
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
Carry out the procedure described in paragraph
7.1. "Disassembling the display".
With the display placed on a work bench:
1. Remove EPROM a from its socket, using an
IC extractor tool.
To reassemble the EPROM:
1. Insert the EPROM pins into the socket
starting from the top, so that the lower holes
of the socket remain free.
2. Make that the reference index b on the
EPROM coincides with the reference notch c
on its socket.
3. Be careful to position the EPROM pins
directly above the holes on the socket.
4. Push the pins into the socket.
The
EPROM
damaged if its reference index is not
correctly matched up with the notch on
the socket, or if its pins are bent.
may
be
irreversibly
Advertisement
Table of Contents
