8.8. LEVELING
Figure 8.8-1
Figure 8.8-2
Figure 8.8-3
Page 8.8
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
1. Remove the plastic cap a from one of the two
rear wheels.
2. Back off the screw b, using an 8-mm hex
wrench.
3. Rotate cam c using the special tool provided,
until all four wheels touch the ground.
4. Lock down screw b, holding the cam in
place.
5. If the two rear feet do not touch the ground,
to adjust them it is necessary to remove the
rear cover as follows:
• Back off the two screws d using a 6-mm
hex wrench;
• remove the cover;
Continued on the following page →