Calibrating The Tread-Belt Speed - Technogym Spazio Forma Service Maintenance Manual

8.6. CALIBRATING THE TREAD-BELT SPEED

Figure 8.6-1
Figure 8.6-2
Page 8.6
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
1. Carry out the procedure described in
paragraph 7.8. "Disassembling the motor
guard".
The operations described below must be
carried out with the machine powered
up; they
exclusively
TECHNICIAN who must ensure that
there are no unauthorized persons near
the machine.
2. Plug the mains lead into the wall outlet.
3. Turn on the machine.
4. Start the tread-belt and set the speed at 8.0
Km/h.
5. View the tread-belt motor control frequency
on the inverter display.
6. Adjust trimmer R36 on the driver board,
accessed through the hole on the electrical
box, as shown in the figure, using a small
flat-blade screwdriver, until the inverter
displays a frequency of 39.8 Hz.
If it is impossible to carry out the
operation by the hole on the electronic
box, open it and adjust the trimmer
shown in figure.
should be performed
by a QUALIFIED