Table of Contents
Advertisement
SPAZIO FORMA: Service & Maintenance manual - rev. 1.0
5. INSTALLATION INSTRUCTIONS
5.1. SPECIFICATIONS AND REQUIREMENTS
For correct machine installation, make sure that:
1. The machine is installed on a level surface that is free of vibrations and has sufficient carrying
capacity for the combined weight of the machine and user.
2. The environment is dust or sand free.
3. The environment meets the operating temperature and humidity conditions specified in
paragraph 2.3. .
4. The machine is not positioned close to sources of heat, sources of electromagnetic noise
(television sets, electric motors, antennas, high voltage lines, appliances etc...) or medical
equipment.
5. To eliminate any interference with the cardio receiver, there should not be any transmitters at a
distance of 100 cm from the display.
6. The mains voltage must match the value specified on the machine rating plate.
7. The electrical system must be provided with an efficient ground connection.
8. The wall outlet used should be reserved for the machine and have a rating of at least 2000 Watt.
9. Do not connect other machines or users to the same wall outlet.
10. Position the mains lead of the machine where is will not be underfoot. For this purpose, it is
recommended to use the special trackways supplied with the machine.
5.2. INSTALLATION
To correctly install the machine, proceed as follows:
1. Ensure that the specifications and requirements for installation have been met (see paragraph
5.1. ).
2. Position the machine as specified above, on a level surface that is free of vibrations and has
sufficient carrying capacity for the combined weight of the machine and the user.
3. The machine is shipped partially disassembled, and packed in a carton fixed to a wooden pallet.
For assembling follow the procedure described in the "User and maintenance manual" supplied
with each machine.
4. Connect the mains lead to the inlet socket on the machine.
5. Place the on/off switch in the "0" position.
6. Plug the mains lead into the electrical outlet.
5.3. FIRST POWER-ON
After completing the installation procedure, the machine is ready to be powered up. To turn on the
machine, simply toggle the on/off switch from the 0 position to the 1 position.
Page 5.1
Advertisement
Table of Contents
