Accessories; Connecting To The Tgs - Technogym Forma Service Maintenance Manual

FORMA: Service & Maintenance manual - rev. 3.0

4. ACCESSORIES

4.1. CONNECTING TO THE TGS

The machine can be connected to the Technogym System by installing a special upgrade kit. The
CPU board is connected to the serial connector via the cable described below, which is supplied
together with the upgrade kit.
To connect a TGS-ready machine, use the RS 232 serial port on the CPU board, made available
through a 9-pin D-connector situated at the rear of the control panel.
The TGS reader is of type 232.
For further details, including troubleshooting information, refer to the manual: "Technogym
System: Installation guide".
Page 4.1