Technogym Forma Service Maintenance Manual page 93

FORMA: Service & Maintenance manual - rev. 3.0
Figura 7.9-3
5. Using a felt-tip pen, mark the top part of both
flywheels as shown in the figure.
6. Disassemble the outer flywheel by backing
off the two screws b using a 4-mm Allen
wrench.
7. Remove the DRIVE-BELT from the tread-
belt motor pulley.
8. Pull out the MOTOR ROLLER, first from
the right hand support and then from the left
hand support.
9. Remove the MOTOR ROLLER from the left
side.
To reassemble the MOTOR ROLLER and the
DRIVE-BELT, carry out the above steps in
reverse order.
To reassemble the flywheels the right
way round, use the markings made
previously.
After completing this procedure, adjust
the tension and centering of the tread-
belt as described in paragraphs 8.2. and
8.3. and adjust
alignment of the DRIVE-BELT as
described in paragraph 8.4.
the tension and
Page 7.11