Technogym Forma Service Maintenance Manual page 91

FORMA: Service & Maintenance manual - rev. 3.0
Figure 7.8-3
Figure 7.8-4
Figure 7.8-5
5. Return the machine to the upright position.
6. Back off the 2 screws c using a 2.5-mm hex
T wrench.
7. Remove the rear plug d.
To facilitate the subsequent tightening
of the belt, shift the seam to the
underside of the machine and measure
out a distance of 1 m on the belt,
marking its ends with a white felt tip
pen.
8. On the right side, back off the 2 nuts e which
clamp the roller earth cable.
9. Slacken the belt tension, backing off the 2
screws f using a 6-mm hex T wrench.
10. Pull the REAR ROLLER out of its supports.
11. Remove the REAR ROLLER from the side.
To reassemble the REAR ROLLER, carry out the
above steps in reverse order.
After completing the procedure, adjust
the tension and centering of the tread-
belt as described in paragraphs 8.2. and
8.3. .
Page 7.9