Microplex PP 404 User Manual page 110

Appendix A Configuration of the printer
The setup of VERT.POS.ADJ. will become effective at the next page of the form.
Attention:
Therefore, it is recommended to perform VERT.POS.ADJ. sets up as long as the paper is in the
park position and before starting the print job.

LEFT MARGIN
1
is set in / Inch steps, depending on the actual selection. The first left margin position is
10
Inch from the left edge of the paper which means that the letter H in regular "Data" font would
be positioned from the left edge of the paper. The left margin can be set to a maximum of
Inch.

RIGHT MARGIN
is set to print position 80, 132 or 136, always measured from the position of the first possible, not
actual, left margin setting.
The left margin setting is influenced by the physical setting of the left tractor. The above
specifications are only correct if the tractors are in the original positions, i.e., the left perforation
is aligned with the center mark on the plastic
plate (distance between the marks is

TOP MARGIN
indicates the first print line and is always set in steps of
is 1 / from the top of the paper and indicates the baseline of the letter H in upright "Data" font
6
(see illustration). The top margin can be set to a maximum of

BOTTOM MARGIN
indicates the last print line. Going beyond this margin automatically initiates a form feed. The
bottom margin is always set in steps of
8
of / Inch Move Up.
6
The above specifications are influenced by the settings in "Vertical Position" (see section "V.POS"
in this chapter).
1
/ Inch.
10
1
/
1
/ Inch. The bottom margin can be set to a maximum
6
Inch. The position of the first margin
6
16
/ down on the paper
6
1
/
20
15
/
10
.
A-10