Table of Contents
Advertisement
3. Installation process
3.3
Installation process stand alone cooler
Installation process from A to Z
1. Assembling of the cooling box housing. The housing is delivered as a flat pack and should be assemble during the installation
process.
2. Mounting of the cooler housing on its support.
3. Mounting the empty cooler assembly on the stand alone frame.
4. Insert the cooler units and filters.
5. Establish the hose connections (4x) between the cooler and the projector. Connect also the four cables.
3.4
Software upgrade
How to upgrade the software
1. Switch on the projector. The projector can now be switched on. Place the ON/OFF switch of the projector in the "I" position. As a
result the projector starts to initialize. The status lights of the projector lights up GREEN once the projector is initialized. In case
the status lights up RED may indicate a tamper event during transport. If so, contact Barco customer service.
2. Download and install the latest version of Communicator. The program can be downloaded for free from Barco's website, (URL:
http://www.barco.com). Click on myBarco and login to get access to secured information. Registration is necessary.
If you are not yet registered, click on New to myBarco and follow the instructions. With the created login and password, it is
possible to login where you can download the software.
3. Download the latest firmware from Barco's website in the same way as for Communicator.
4. Start Communicator and make a connection with the projector. For more information, consult the Communicator user guide.
5. Login as service technician and click on tab Maintenance and select Software update.
6. Click on Launch DC update companion.
7. Click Next, accept the license agreement and continue following the wizard.
3.5
Starting up and adjusting the system
Adjustment steps
1. Select the corresponding lens parameters for the installed lens. See user guide of the Communicator chapter Installation >
Advanced > Lens parameters.
2. Alignment of the projected image on the screen. The image can be aligned with the screen size of the application. Follow
the next steps to achieve that:
a) Press the STANDBY button on the Local Keypad to activate the lamp.
b) Press the DOWSER button on the Local Keypad to open the electronic dowser of the projector. The electronic dowser is open
if the color of the DOWSER button is GREEN.
c) Press the TEST PATTERN button on the Local Keypad to project one of the internal test patterns of the projector on the
screen.
d) Perform a "Lens Homing". See user guide of the Communicator.
e) Use the lens ZOOM, SHIFT and FOCUS buttons on the Local Keypad to match the projected image with the screen. Tilt the
projector in case you can not SHIFT the image completely upon the screen. See "Lens shift, zoom & focus", page 69.
See chapter "Local keypad of the DPxK-xxBLP ", page 80, for detailed description of the Local Keypad buttons.
3. Adjusting the light path. Normally the lens holder and the convergence of the projector are perfectly adjusted at the factory.
Nevertheless, some applications require a readjustment of the lens holder, convergence or both. See procedure "Scheimpflug
adjustment", page 74, and "Convergence", page 149.
4. Creating screen files, lens files, light sensor calibration (LSC) files, and macro files for FLAT and for SCOPE. See user
guide of the Communicator.
5. Perform Color calibration. See chapter "Color calibration", page 155.
6. Create light sensor calibration (LSC) files. See user guide of the Communicator.
7. Backup of all projector configuration files. See user guide of the Communicator.
8. Registration of the projector. The DPxK BLP series projector is DCI compliant and should be registered.
24
R5906753 DPXK BLP SERIES 20/11/2017
Advertisement
Table of Contents
