Time Display - Planmeca ProX User Manual

8 CONTROL PANEL

8.1.3 Time display

kV display
1
2
9
10
11
12
12 Planmeca ProX
mA display Sensor type
A -
A -
A Planmeca
ProSensor
A
A
A -
The selected exposure time is shown on the time display.
After taking an exposure a waiting time starts to flash on
the time display which indicates the delay before the next
exposure can be taken.
In the digital imaging mode the exposure time is shown
d.
with the prefix
In the imaging plate mode the exposure time is shown
P.
with the prefix .
In the film mode there is no prefix in the exposure time
field.
After exposure the WAIT time appears on the display. The
wait time is 15 times the time of exposure, however
always at least 6 seconds.
If the DAP display is activated (service mode parameter
24=1 or 3) the WAIT time display changes to DAP display
after a few seconds. In this case the beam limiting device
number (between 1 and 12) appears on the
The letter A is shown in the
(0.1 - 9.9, 10 - 9999 mGy*cm2) appears on the s (time)
display.
The beam limiting devices can be selected using the
arrow keys.
Table 1: Beam limiting devices
Explanation
No tube
Round tube without supplementary
limiting device
Round tube + S0 black, size 0
Round tube + S1 black, size 1
Round tube + S2 black, size 2
Rectangular tube without
supplementary limiting device
See also the technical manual for DAP values of the 1, 2
and 12 beam limiting devices.
kV
display.
mA
display and the DAP value
Part number
-
-
10021314
10021315
10021316
-
User's manual