Keys And Indicator Lights - Planmeca ProX User Manual

8.2 Keys and indicator lights

8.2.1 Preprogrammed settings keys and indicator lights
1
2
3
8.2.2 Adult/child mode selection key and indicator light
8.2.3 SELECT key
User's manual
The unit is preprogrammed with exposure parameters -
time, kV and mA values - which can be selected by
pressing these keys. There are ten sets of parameters for
both the child mode and the adult mode: one for each
exposure region and one for default exposure values,
which are in use when an exposure region is not selected.
4
The selections that can be made are:
1 Incisors
5
2 Premolars and canines
6
3 Molars
7
Press the desired key once to select the projection of the
maxilla. The indicator light of the selected projection will
come on.Press the key twice to select the projection of the
mandible. The indicator light of the selected projection will
come on.
Pressing the key a third time will recall the default
exposure values.
The preprogrammed settings can be changed by the user,
see section 16.1 "Programming default exposure values"
on page 34.
Press the adult/child mode selection key once to select
the child mode. The indicator light of the child mode will
come on.
Press the key again to return to the adult mode. The
indicator light of the adult mode will come on.
Press the SELECT key briefly to select the parameter -
kV, mA or exposure time - to be changed. When the
parameter value is flashing on the display, the parameter
can be changed. After adjusting the kV or mA value or
exposure time the unit will return automatically to the time
adjustment mode after 5 seconds time.
Press and hold down the SELECT key (about 4 seconds)
until you have heard two signal tones to enter the
programming mode. For more information about
programming refer to chapter 16.1 "Programming default
exposure values" on page 34.
Press the SELECT key to clear the error from the display.
8 CONTROL PANEL
4 Occlusal exposure
5 Endodontic exposure
6 Bite-wing exposure
7 Adult/child mode
Planmeca ProX 13