Table of Contents
Advertisement
Operation
SCREEN Settings
The SCREEN settings control the size and position of the output to DVI1 OUT and DVI2+VGA OUT. To
access and adjust the SCREEN settings, do the following:
1.
Access the
OUTPUT
2.
Use the <SELECT> knob to select SCREEN.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select from H SIZE (horizontal size), V SIZE (vertical size), H POS
(horizontal position), or V POS (vertical position).
5.
Press the <SELECT> knob.
6.
Turn the <SELECT> knob to increase or decrease the selected parameter.
7.
Press the <SELECT> knob.
8.
Use the <SELECT> knob to select MODE.
9.
Press the <SELECT> knob.
10. Use the <SELECT> knob to select either FULL SIZE (outputs unscaled video) or SCREEN SIZE
(outputs scaled video).
11. Press the <SELECT> knob.
12. If necessary, to reset the SCREEN settings, use the <SELECT> knob to select RESET and press
the <SELECT> knob.
RATIO
The RATIO setting sets the aspect ratio of the output from DVI1 OUT. To set the RATIO setting, follow the
instructions below.
1.
Access the
OUTPUT
2.
Use the <SELECT> knob to select RATIO.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select an aspect ratio, from 4:3, 16:9, or NORMAL (does not alter
the aspect ratio).
5.
Press the <SELECT> knob.
PICTURE Settings
The PICTURE settings control the color balance and related aspects of the output from DVI1 OUT. To
access and adjust the PICTURE settings, do the following:
1.
Access the
OUTPUT
2.
Use the <SELECT> knob to select PICTURE.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select a setting to adjust, from BRIGHTNESS, CONTRAST,
SATURATION, SHARPNESS, COLOR RED, COLOR GRN, or COLOR BLUE. To reset the
PICTURE settings, select RESET.
5.
Press the <SELECT> knob.
6.
Turn the <SELECT> knob to increase or decrease the selected parameter.
7.
Press the <SELECT> knob.
8.
Repeat steps 4 to 7 until the product outputs as desired.
Picture In Picture
The Picture In Picture (PIP) settings allow 2 video inputs to display simultaneously. To access and enable
or disable the PIP settings, follow the instructions below.
1.
Access the
OUTPUT
2.
Use the <SELECT> knob to select PIP.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select PIP.
5.
Press the <SELECT> knob.
6.
Use the <SELECT> knob to select either OFF (disables PIP) or ON (enables PIP).
7.
Press the <SELECT> knob.
Vivid Drive 23N User Manual Rev. 1
Settings.
Settings.
Settings.
Settings.
Page 16 of 31
Advertisement
Table of Contents
