Table of Contents
Advertisement
DEINTERLACE
The DEINTERLACE function converts interlaced video signals to a non-interlaced format. To enable or
disable deinterlacing, follow the instructions below.
1.
Access the
TRANSITION
2.
Use the <SELECT> knob to select DEINTERLACE.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select either ON (deinterlaces video signals) or OFF (does not
deinterlace video signals).
5.
Press the <SELECT> knob.
SPLIT Settings
The SPLIT settings split the video input into sections to output from 2 or more Vivid Drive 23N products
onto the same connected panel assembly. This allows larger panel assemblies than can be controlled by a
single Vivid Drive 23N. To access and enable or disable the SPLIT settings, do the following:
1.
Press the <SELECT> knob to enter the menu.
2.
Use the <SELECT> knob to select SPLIT.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select SPLIT.
5.
Press the <SELECT> knob.
6.
Use the <SELECT> knob to select either OFF (disables SPLIT) or ON (enables SPLIT).
7.
Press the <SELECT> knob.
SPLIT Total
The SPLIT total settings H TOTAL and V TOTAL determine the total size of the connected panel
assembly. To set the totals, follow the instructions below.
1.
Access and enable the
2.
Use the <SELECT> knob to select either H TOTAL (total horizontal size) or V TOTAL (total
vertical size).
3.
Press the <SELECT> knob.
4.
Turn the <SELECT> knob to increase or decrease the selected parameter.
5.
Press the <SELECT> knob.
6.
Repeat steps 2 to 5 until the total size of the connected panel assembly is set accurately.
SPLIT Position and Size
The SPLIT position (H POS and V POS) and size (H SIZE and V SIZE) settings determine the location and
size of a specific Vivid Drive 23N product's output on the connected panel assembly. To set the position
and size, do the following:
1.
Access and enable the
2.
Use the <SELECT> knob to select from H POS (horizontal position), V POS (vertical position),
H SIZE (horizontal size), or V SIZE (vertical size).
3.
Press the <SELECT> knob.
4.
Turn the <SELECT> knob to increase or decrease the selected parameter.
5.
Press the <SELECT> knob.
6.
Repeat steps 2 to 5 until the size and position are set as desired.
SAVE SETUP Settings
The SAVE SETUP settings allow up to 10 different configurations of the Vivid Drive 23N to be stored and
reloaded. To access the SAVE SETUP settings, follow the instructions below.
1.
Press the <SELECT> knob to enter the menu.
2.
Use the <SELECT> knob to select SAVE SETUP.
3.
Press the <SELECT> knob.
SAVE TO
The SAVE TO function saves the currently set configurations of the Vivid Drive 23N to one of 10 SAVE
slots. To save the current configuration of the Vivid Drive 23N, do the following:
1.
Access the
SAVE SETUP
2.
Use the <SELECT> knob to select SAVE TO.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select a save slot, from SAVE 1–10.
5.
Press the <SELECT> knob.
Page 21 of 31
Settings.
SPLIT
Settings.
SPLIT
Settings.
Settings.
Operation
Vivid Drive 23N User Manual Rev. 1
Advertisement
Table of Contents
