Table of Contents
Advertisement
TEST PATTERN
To set the Vivid Drive 23N to output a specific test pattern from DVI1 OUT, do the following:
1.
Access the
DISPLAY MODE
2.
From the DISPLAY MODE menu level, use the <SELECT> knob to select TEST PATTERN.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select TEST PATTERN.
5.
Press the <SELECT> knob.
6.
Use the <SELECT> knob to select a test pattern, from 1–66.
7.
Press the <SELECT> knob.
To set if and how often the TEST PATTERN switches from one to the next:
1.
From the first TEST PATTERN menu level, use the <SELECT> knob to select AUTO SWITCH.
2.
Press the <SELECT> knob.
3.
Use the <SELECT> knob to select from OFF (will not switch automatically between test patterns)
or from 1–10s (sets the interval between switches from 1 to 10 seconds).
4.
Press the <SELECT> knob.
For TEST PATTERN 65, the color and number of vertical and horizontal steps can be customized. To do
so:
1.
From the first TEST PATTERN menu level, use the <SELECT> knob to select from RED,
GREEN, BLUE, HOR STEP (horizontal steps), or VER STEP (vertical steps).
2.
Press the <SELECT> knob.
3.
Turn the <SELECT> knob to increase or decrease the selected parameter.
4.
Press the <SELECT> knob.
5.
Repeat steps 1 to 4 until the TEST PATTERN appears as desired.
For TEST PATTERN 66, the color can be chosen. To do so:
1.
From the first TEST PATTERN menu level, use the <SELECT> knob to select COLOR.
2.
Press the <SELECT> knob.
3.
Use the <SELECT> knob to select from RED, GREEN, BLUE, or WHITE.
4.
Press the <SELECT> knob.
FLAT COLOR
To set the Vivid Drive 23N to output a custom static color from DVI1 OUT, follow the instructions below.
1.
Access the
DISPLAY MODE
2.
From the DISPLAY MODE menu level, use the <SELECT> knob to select FLAT COLOR.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select which color level to adjust, from RED, GREEN, or BLUE.
5.
Press the <SELECT> knob.
6.
Turn the <SELECT> knob to increase or decrease the selected color value, from 0–255.
7.
Press the <SELECT> knob.
8.
Repeat steps 4 to 7 until the color is set as desired.
GAMMA
To set the GAMMA correction, do the following:
1.
Access the
OUTPUT
2.
Use the <SELECT> knob to select GAMMA.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select from LINEAR, sRGB, -1.2, 1.2, -1.4, 1.4, -1.6, or 1.6.
5.
Press the <SELECT> knob.
Page 19 of 31
setting, and set the MODE to TEST PATTERN.
setting, and set the MODE to FLAT IMAGE.
Settings.
Operation
Vivid Drive 23N User Manual Rev. 1
Advertisement
Table of Contents
