Configuration (Settings); Dimmer Speed; Factory Reset; Irc-6 Infrared Remote Control - Chauvet DJ LED SHADOW 2 ILS User Manual

Configuration (Settings)

Factory Reset

To reset the LED Shadow 2 ILS to factory default settings, do the following:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select rESt.
4. Press <ENTER>.

IRC-6 Infrared Remote Control

The LED Shadow 2 ILS is compatible with the IRC-6 infrared remote control from Chauvet. To run the LED
Shadow 2 ILS in IR mode, follow the instructions below.
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ir.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select from oFF or on.
6. Press <ENTER>.

IRC-6 Operation

Automatic Programs
To run an automatic program with the IRC-6, press <AUTO>
FADE
To run the FADE program with the IRC-6, press <FADE>.
To set the program speed with the IRC-6:
BLACK
AUTO SOUND
OUT Sound-Active Mode
To run the sound-active mode with the IRC-6, press <SOUND>.
SENSI-
STROBE SPEED
TIVITY
To set the sound sensitivity with the IRC-6:
%
MANUAL FADE
R G B
Manual Mode
To mix a custom color with the IRC-6:
A UV W
-
+
0
1 2 3
4 5 6
To select a preset color with the IRC-6:
7 8 9
Strobe
To adjust the strobe rate with the IRC-6:
Black Out
To black out the lights with the IRC-6, press <BLACK OUT>.
This will turn off all the lights until the button is pressed again.
Page 10 of 15
1. Press <AUTO> on the IRC-6.
2. Press <+> or <–> to select the program.
1. Press <FADE> on the IRC-6.
2. Press <+> or <–> to select the program.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
1. Press <MANUAL> on the IRC-6.
2. Press <R> (red), <G> (green), <B> (blue), or <A> (amber) to select which
color to edit.
3. Press <+> or <–> to increase or decrease the value of the selected color.
1. Press <MANUAL> on the IRC-6.
2. Press <P/UV>, <W>, or <0>–<9> to select the color.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe, or set the strobe to 0.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If
the product does not respond when a button is pressed, try pressing <BLACK
OUT>. Black Out may have been activated.
LED Shadow 2 ILS User Manual Rev. 1
Operation