Table of Contents
Advertisement
DATA RANGE
The DATA RANGE setting determines the color space of the output. To set the DATA RANGE, follow the
instructions below.
1.
Access the
OUTPUT ADJUST
2.
Use the <SELECT> knob to select DATA RANGE.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select either IMAGE (RGB color space) or VIDEO (YUV color
space).
5.
Press the <SELECT> knob.
DE ADJUST
The DE ADJUST settings control the digital encoding. To access and adjust the DE ADJUST settings, do
the following:
1.
Access the
OUTPUT ADJUST
2.
Use the <SELECT> knob to select DE ADJUST.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select DE.
5.
Press the <SELECT> knob.
6.
Use the <SELECT> knob to select ON (to enable the DE ADJUST settings) or OFF (to disable
the DE ADJUST settings). This must be set to ON for the DE ADJUST settings to work.
7.
Press the <SELECT> knob.
To set the position and size:
1.
From the DE ADJUST menu level, use the <SELECT> knob to select from H POS (horizontal
position), V POS (vertical position), H SIZE (horizontal size), or V SIZE (vertical size).
2.
Press the <SELECT> knob.
3.
Turn the <SELECT> knob to increase or decrease the selected value.
4.
Press the <SELECT> knob.
5.
Repeat steps 1 to 4 until the position and size is set as desired.
To set the phase/polarity:
1.
From the DE ADJUST menu level, use the <SELECT> knob to select H POLARITY (horizontal
phase) or V POLARITY (vertical phase).
2.
Press the <SELECT> knob.
3.
Use the <SELECT> knob to select either POS (positive) or NEG (negative).
4.
Press the <SELECT> knob.
5.
Repeat steps 1 to 4 until the polarities are set as desired.
If necessary, to reset the DE ADJUST settings:
1.
From the DE ADJUST menu level, use the <SELECT> knob to select RESET.
2.
Press the <SELECT> knob.
SCALE Settings
The SCALE settings control the size and position of the output from DVI1 OUT. To access and adjust the
SCALE settings, follow the instructions below.
1.
Access the
OUTPUT Settings
2.
Use the <SELECT> knob to select SCALE.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select from H SIZE (horizontal size), V SIZE (vertical size), H POS
(horizontal position), or V POS (vertical position). To reset the SCALE settings, select RESET.
5.
Press the <SELECT> knob.
6.
Turn the <SELECT> knob to increase or decrease the selected parameter, or enter the desired
value using the number buttons.
7.
Press the <SELECT> knob.
8.
Repeat steps 4 to 7 until the SCALE is set as desired.
Page 15 of 31
settings.
settings.
(or press <SCALE/7> and skip to step 4).
Operation
Vivid Drive 23N User Manual Rev. 1
Advertisement
Table of Contents
