Getting Started - Chauvet DJ Vivid Drive 23N User Manual

Getting Started

To set up a new assembly of Vivid 4 video panels with a Vivid Drive 23N, follow the instructions below.
1. Download LCTMars (not Mac compatible) or SmartLCT from
drive-23n/.
2. Install the selected software.
3. Connect and cable the Vivid 4 panel assembly according to the Vivid 4 User Manual (available at
www.chauvetdj.com).
4. Connect the Vivid 4 panel assembly to power
5. Connect the Vivid Drive 23N to power.
6. Connect the Vivid 4 panel assembly to Ethernet Out 1 on the Vivid Drive 23N. (See
Overview)
7. Connect the computer to USB B 2 on the Vivid Drive 23N. (See
8. Run the software and follow instructions from LCTMars or SmartLCT to map the video panel
assembly as desired.
9. Connect the video source to the Vivid Drive 23N.
Using the internal scaler of the Vivid Drive 23N:
a. Connect the DVI to DVI jumper as shown in
b. Connect the video source to HDMI IN, VGA/YPbPr IN, or CVBS IN.
c. Press the button that corresponds with the video source being used (<HDMI/2>, <VGA/4>,
<YPbPr/5>, or <CV/1>). (See
d. Send video signal to the Vivid Drive 23N.
e. Follow the
assembly.
Using pre-scaled video, bypassing the internal scaler of the Vivid Drive 23N:
a. Connect the video source to DVI In.
b. Send video signal to the Vivid Drive 23N.
Page 27 of 31
Front
SCALE Settings instructions to fit the video output to the connected panel
www.chauvetdj.com/products/vivid-
Rear
Connection Diagram.
Overview)
Vivid Drive 23N User Manual Rev. 1
Operation
Rear
Overview)