Configuration (Settings); Pan Reverse; Tilt Reverse; Screen Reverse - Chauvet DJ Intimidator Beam Q60 User Manual

Operation

Configuration (Settings)

Pan Reverse

To set the pan orientation on the Intimidator Beam Q60, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Pan Reverse.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal pan orientation) or ON (reverse pan orientation).
7. Press <ENTER>.

Tilt Reverse

To set the tilt orientation on the Intimidator Beam Q60, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt Reverse.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal tilt orientation) or ON (reverse tilt orientation).
7. Press <ENTER>.

Screen Reverse

To set the display orientation on the Intimidator Beam Q60, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Screen Reverse.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal display orientation) or ON (reverse display
orientation).
7. Press <ENTER>.

Pan Angle

To set the pan angle range on the Intimidator Beam Q60, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Pan Angle.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from 540 (540°), 360 (360°), or 180 (180°).
7. Press <ENTER>.

Tilt Angle

To set the tilt angle range on the Intimidator Beam Q60, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt Angle.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from 260 (260°), 180 (180°), or 90 (90°).
7. Press <ENTER>.

Totem Mode

To activate the Totem mode, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Totem Mode.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal range of motion), UP (upward tilt range), or DOWN
(downward tilt range).
7. Press <ENTER>.
Intimidator Beam Q60 User Manual Rev. 1 Page 13 of 19