Table of Contents
Advertisement
Operation
TRANSITION Settings
The TRANSITION settings determine how the Vivid Drive 23N displays the switch when changing video
sources. To access the TRANSITION settings, follow the instructions below.
1.
Press the <SELECT> knob to enter the menu.
2.
Use the <SELECT> knob to select TRANSITION.
3.
Press the <SELECT> knob.
Transition MODE
The MODE determines the effect used when the Vivid Drive 23N transitions from one video source to
another. To set the transition MODE, do the following:
1.
Access the
TRANSITION
2.
Use the <SELECT> knob to select MODE.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select an effect, from:
•
CUT (no effect),
•
FADE (fade effect),
•
POP L+T (new video enters from top left),
•
PUSH L+T (old video exits at top left),
•
POP R+T (new video enters from top right),
•
PUSH R+T (old video exits at top right),
•
POP L+B (new video enters from bottom left),
•
PUSH L+B (old video exits at bottom left),
•
POP R+B (new video enters from bottom right),
•
PUSH R+B (old video exits at bottom right),
•
POP CENT (new video expands from the center),
•
PUSH CENT (old video shrinks into the center),
•
POP LEFT (new video enters from the left),
•
PUSH LEFT (old video exits to the left),
•
POP RIGHT (new video enters from the right),
•
PUSH RIGHT (old video exits to the right),
•
POP TOP (new video enters from the top),
•
PUSH TOP (old video exits to the top),
•
POP BOTTOM (new video enters from the bottom),
or
•
PUSH BOTTOM (old video exits to the bottom).
5.
Press the <SELECT> knob.
FADE TIME
The FADE TIME setting determines the length of time it takes for a transition to complete. To set the FADE
TIME, follow the instructions below.
1.
Access the
TRANSITION
2.
Use the <SELECT> knob to select FADE TIME.
3.
Press the <SELECT> knob.
4.
Turn the <SELECT> knob to increase or decrease the amount of time, from 0.0–1.0s (seconds).
5.
Press the <SELECT> knob.
Transition ALPHA
The ALPHA setting controls the transparency of transitioning video sources. To set the ALPHA, do the
following:
1.
Access the
TRANSITION
2.
Use the <SELECT> knob to select ALPHA.
3.
Press the <SELECT> knob.
4.
Turn the <SELECT> knob to increase or decrease the transparency, from 0–16.
5.
Press the <SELECT> knob.
Vivid Drive 23N User Manual Rev. 1
Settings.
Settings.
Settings.
Page 20 of 31
Advertisement
Table of Contents
