Table of Contents
Advertisement
Operation
Tilt Reverse
To set the tilt orientation on the Intimidator Spot 160 ILS, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt Reverse.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal tilt orientation) or ON (reverse tilt orientation).
7. Press <ENTER>.
Screen Reverse
To set the display orientation on the Intimidator Spot 160 ILS, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Screen Reverse.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal display orientation) or ON (reverse display orientation).
7. Press <ENTER>.
Pan Angle
To set the pan angle range on the Intimidator Spot 160 ILS, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Pan Angle.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from 540 (540°), 360 (360°), or 180 (180°).
7. Press <ENTER>.
Tilt Angle
To set the tilt angle range on the Intimidator Spot 160 ILS, follow the instructions below:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Tilt Angle.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select from 229 (229°), 180 (180°), or 90 (90°).
7. Press <ENTER>.
Totem Mode
To activate the Totem mode, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Totem Mode.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (normal range of motion), UP (restricts the pan and tilt motion
for overhead mounting), or DOWN (restricts the pan and tilt motion for surface/floor mounting).
7. Press <ENTER>.
DMX Loss
To set the action the Intimidator Spot 160 ILS will do when signal is lost, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select DMX Loss.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select Hold (holds the last setting), Black (blacks out the product),
Auto (sets the unit to auto mode), or Sound (sets the unit to sound mode).
7. Press <ENTER>.
Intimidator Spot 160 ILS User Manual Rev. 2
11
Advertisement
Table of Contents
