Table of Contents
Advertisement
Setup
3. Setup
AC Power
The Vivid Drive 23N has an auto-ranging power supply and it can work with an input voltage range of 100
to 240 VAC, 50/60 Hz. To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or refer to the product's
specifications chart. The listed current rating indicates the product's average current draw under normal
conditions.
•
Always connect the product to a protected circuit (a circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
Orientation
The Vivid Drive 23N comes with a Rack Mount Adapter for mounting the product in a standard 19" rack.
Rigging
•
Before deciding on a location, always make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure adequate ventilation is provided around the product.
•
Make sure that the structure or surface onto which you are mounting the product can support the
product's weight. (see the
Mounting Diagram
Rack Mount Adapter
Signal Connections
The Vivid Drive 23N uses the NOVA control protocol to send video signal to the connected panels. The Vivid
Drive 23N has USB and Ethernet ports for interfacing with a computer, an HDMI port for unscaled video
input, a DVI port for scaled video input, as well as 2 ethernet out ports, and both HDMI and DVI out ports.
Video Source Connection
You can link the Vivid Drive 23N directly to a video source using a DVI connection (for pre-scaled video
sources) or an HDMI connection (for unscaled video sources). There is also a BNC connector for CVBS
input and a DE-15 connector for VGA or YPbPr input.
NovaLCTMars Connection
You can link the Vivid Drive 23N to a computer running the NovaLCTMars software using a USB (type B)
connection. This will provide control and mapping options for the Vivid Drive 23N through a computer interface.
Preview Monitor Connection
You can link the Vivid Drive 23N to a monitor that will preview the LED output using a DVI cable plugged
into the DVI2+VGA OUT port or an HDMI cable plugged into the HDMI LOOP port.
Vivid Drive 23N User Manual Rev. 1
Technical
Specifications)
Safety
Empty Slot Cover
Insert into slot and
secure with screws
Page 6 of 31
Notes.
Advertisement
Table of Contents
