Table of Contents
Advertisement
Operation
Settings Configuration
Pan Reverse
To set the pan orientation on the Intimidator Scan 360, follow the instructions below:
1. Press <MENU> repeatedly until Setup shows on the display.
2. Press <ENTER>.
3. Press <MENU> repeatedly until Pan Reverse shows on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select OFF (normal pan orientation) or ON (reverse pan orientation).
6. Press <ENTER>.
Tilt Reverse
To set the tilt orientation on the Intimidator Scan 360, do the following:
1. Press <MENU> repeatedly until Setup shows on the display.
2. Press <ENTER>.
3. Press <MENU> repeatedly until Tilt Reverse shows on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select OFF (normal tilt orientation) or ON (reverse tilt orientation).
6. Press <ENTER>.
Screen Reverse
To set the screen display on the Intimidator Scan 360, follow the instructions below:
1. Press <MENU> repeatedly until Setup shows on the display.
2. Press <ENTER>.
3. Press <MENU> repeatedly until Screen Reverse shows on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select OFF (normal screen display) or ON (reverse screen display).
6. Press <ENTER>.
Signal Loss
To set the action that the Intimidator Scan 360 does once DMX signal is lost, follow the instructions below:
1. Press <MENU> repeatedly until Setup shows on the display.
2. Press <ENTER>.
3. Press <MENU> repeatedly until Signal Loss shows on the display.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select Blackout (turns the unit off), Hold (retains the last setting), Auto
(sets the unit to Auto mode), or Sound (sets the unit to Sound mode).
6. Press <ENTER>.
Indicator
To enable or disable the LED indicator, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Indicator.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (disabled) or ON (enabled).
7. Press <ENTER>.
Flash if DMX
To enable or disable the LED indicator flashing to indicate DMX, do the following:
1. Press <MENU>.
2. Use <UP> or <DOWN> to select Setup.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Flash if DMX.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select OFF (will not indicate DMX) or ON (Will indicate DMX).
7. Press <ENTER>.
Intimidator Scan 360 User Manual Rev. 3
11
Advertisement
Table of Contents
