Table of Contents
Advertisement
Operating Settings Configuration
INPUT Settings
The INPUT settings define the parameters of the video source to be edited by the internal scaler of the
Vivid Drive 23N. To access the INPUT settings, do the following:
1.
Press the <SELECT> knob to enter the menu.
2.
Use the <SELECT> knob to select INPUT.
3.
Press the <SELECT> knob.
INPUT DETAIL
To view which input is currently selected, follow the instructions below.
1.
Access the
INPUT
2.
Use the <SELECT> knob to select INPUT DETAIL.
3.
Press the <SELECT> knob.
ZOOM ADJUST
The ZOOM ADJUST settings select which portion of the video input to be processed by the internal scaler.
To access and adjust the ZOOM ADJUST settings, do the following:
1.
Access the
INPUT
2.
Use the <SELECT> knob to select ZOOM ADJUST.
1.
Press the <SELECT> knob.
2.
Use the <SELECT> knob to select which direction (or directions) to stretch the video input, from
V UP (upwards), V DOWN (downwards), V UP/DOWN (both up and down), H LEFT (leftwards),
H RIGHT (rightwards), H LEFT/RIGHT (both left and right), or CENTER (all 4 directions). To reset
all zoom values, select RESET.
3.
Press the <SELECT> knob.
4.
Turn the <SELECT> knob to increase or decrease the selected zoom value.
5.
Press the <SELECT> knob.
6.
Repeat steps 2 to 5 until the zoom is set as desired.
VGA ADJUST
The VGA ADJUST settings adjust the position and synchronization of a VGA video source. To access and
adjust the VGA ADJUST settings, follow the instructions below.
1.
Access the
INPUT
2.
Use the <SELECT> knob to select VGA ADJUST.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select which setting to adjust, from H POS (horizontal position),
V POS (vertical position), CLOCK (input signal clock), or PHASE (input signal phase). To set the
Vivid Drive 23N to automatically select the optimum settings, select AUTO ADJUST.
5.
Press the <SELECT> knob.
6.
If not using the AUTO ADJUST function, turn the <SELECT> knob to increase or decrease the
selected value.
7.
Press the <SELECT> knob.
8.
Repeat steps 4 to 7 until the signal is adjusted as desired.
ADC ADJUST
The ADC ADJUST setting controls the analog to digital conversion. To set the ADC ADJUST, do the
following:
1.
Access the
INPUT
2.
Use the <SELECT> knob to select ADC ADJUST.
3.
Press the <SELECT> knob.
4.
Use the <SELECT> knob to select ADC AUTO ADJUST (to automatically adjust the ADC setting)
or ADC RESET ALL (to reset the ADC setting).
5.
Press the <SELECT> knob.
6.
Press the <SELECT> knob to confirm, or <MENU> to cancel.
Page 13 of 31
Settings.
Settings.
Settings.
Settings.
Operation
Vivid Drive 23N User Manual Rev. 1
Advertisement
Table of Contents
