Table of Contents
Advertisement
Operation
Settings Configuration
Dimmer Speed
To set the dimmer speed of the SlimBANK H18 ILS, do the following:
1. Press <MENU> repeatedly until diN shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the speed, from oFF (instant/linear dimmer), diN1 (fast), diN2
(medium), or diN3 (slow).
4. Press <ENTER>.
Factory Reset
To reset the SlimBANK H18 ILS to factory default settings, do the following:
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select rESt.
4. Press <ENTER>.
IRC-6 Infrared Remote Control
The SlimBANK H18 ILS is compatible with the IRC-6 infrared remote control from Chauvet. To run the
SlimBANK H18 ILS in IR mode, follow the instructions below.
1. Press <MENU> repeatedly until SEt shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select ir.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to select from oFF or on.
6. Press <ENTER>.
IRC-6 Operation
Automatic Programs
To run an automatic program with the IRC-6:
To set the program speed with the IRC-6:
Sound-Active Mode
To run the sound-active mode with the IRC-6, press <SOUND>.
BLACK
AUTO
SOUND
To set the sound sensitivity with the IRC-6:
OUT
SENSI-
STROBE
SPEED
TIVITY
Manual Mode
%
MANUAL
FADE
To mix a custom color with the IRC-6:
R
G
B
A
UV
W
-
+
0
To select a preset color with the IRC-6:
1
2
3
4
5
6
Strobe
7
8
9
To adjust the strobe rate with the IRC-6:
Black Out
To black out the lights with the IRC-6, press <BLACK OUT>.
This will turn off all the lights until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
SlimBANK H18 ILS User Manual Rev. 1
1. Press <AUTO> on the IRC-6 (or press <FADE> to select P 14).
2. Press <+> or <–> to select the program.
1. Press <SPEED> on the IRC-6.
2. Press <+> or <–> to increase or decrease the speed.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
1. Press <MANUAL> on the IRC-6.
2. Press <R> (red), <G> (green), <B> (blue), <A> (amber), <W> (white), or
<UV> (ultraviolet) to select which color to edit.
3. Press <+> or <–> to increase or decrease the value of the selected color.
1. Press <MANUAL> on the IRC-6.
2. Press <P/UV>, <W>, or <0>–<9> to select the color.
1. Press <STROBE> on the IRC-6.
2. Press <+> or <–> to increase or decrease the strobe rate.
3. Press <STROBE> again to turn off the strobe, or set the strobe to 0.
12
Advertisement
Table of Contents
