Monitoring The Device; Interpreting Port-Side Leds - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

Monitoring the Device

•

Interpreting port-side LEDs......................................................................................................................................91

• Interpreting nonport-side LEDs................................................................................................................................98
• Pinging an IP address..............................................................................................................................................98
• Tracing a route........................................................................................................................................................ 98
• Digital optical monitoring......................................................................................................................................... 99
• Monitoring power and cooling................................................................................................................................. 99
Interpreting port-side LEDs
After you install the network cables, you can observe certain LEDs to determine if the network connections are functioning properly. The
tables in this section outline the state of each LED, the status of the hardware, and any recommended action.
FIGURE 61 Port-side LEDs of ICX 7150-C12P
1. Port status mode selection button
2. Port link status mode LED
3. Port speed status mode LED
4. Member ID status mode LED
5. USB status mode LED
6. PoE status mode LED
7. System Status LED
8. Master/Slave status LED
9. Software update status LED
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
10. RJ-45 port 5 RX/TX activity LED (if blinking indicates RX/TX activity)
11. PoE LED
12. RJ-45 uplink port C1 status LED
13. RJ-45 uplink port C1 RX/TX activity LED
14. SFP+ uplink port X1 status LED (if blinking indicates RX/TX activity)
15. SFP+ uplink port X2 status LED (if blinking indicates RX/TX activity)
16. Power status LED
17. Cloud management status LED (not currently enabled)
18. Diagnostics status LED
91