Attaching The Bracket Extensions To The Front Of The Device - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 40 Attaching the front brackets to the rear of the device
1. Brocade device
2. Front brackets

Attaching the bracket extensions to the front of the device

Complete the following steps to attach the bracket extensions to the front of the device.
1. Position the right bracket extension along the side of the device as shown in
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket extension and then into the holes on
the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat step 1 and step 2 to attach the left front bracket extension to the left side of the device.
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
Flush-rear (recessed) mounting the device in the rack
3. Screws, 8-32 x 5/16-in., flathead Phillips
Figure 41.
Mounting the Device
63