Attaching The Front Brackets - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

Mounting the Device
Flush-front mounting the device in the rack
Complete the following tasks to install the device in a four-post rack:
1.

Attaching the front brackets

2. Attaching the bracket extensions to the device
3. Installing the device in the rack
4. Attaching the rear brackets to the extensions
5. Attaching the rear brackets to the rack posts
Attaching the front brackets
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device at the front of the device, as shown in
34.
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the side of
the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat Step 1 and
56
on page 56
on page 58
on page 59
on page 61
Step 2 to attach the left front bracket to the left side of the device.
on page 57
Figure
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05