1.
Rear bracket, medium or long
2.
Screws, 6-32 x 1/4-in., panhead Phillips
Attaching the rear brackets to the rack posts
Complete the following steps to attach the rear brackets to the rack posts.
1.
Attach the right rear bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts, as shown
in
Figure
39. Use the upper and lower holes in the bracket.
2.
Attach the left rear bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 39 Attaching the rear brackets to the rack posts
1.
Screws, 10-32 x 5/8-in., panhead Phillips
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
Flush-front mounting the device in the rack
2.
Retainer nuts, 10-32
Mounting the Device
61