Preparing For The Installation; Safety Precautions; General Precautions; Esd Precautions - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

Preparing for the Installation

•

Safety precautions...................................................................................................................................................21

• Facility requirements................................................................................................................................................23
• Quick installation checklist.......................................................................................................................................24
• Shipping carton contents........................................................................................................................................ 26
Safety precautions
When using this product, observe all danger, caution, and attention notices in this manual. The safety notices are accompanied by symbols
that represent the severity of the safety condition
Refer to Cautions and Danger Notices at the end of this guide for translations of safety notices for this product.

General precautions

DANGER
The procedures in this manual are for qualified service personnel.
DANGER
Before beginning the installation, see the precautions in "Power precautions."
DANGER
The equipment ports are intra-building type and must not be directly connected to metallic outside plant (OSP) cable conductors.
CAUTION
Changes or modifications made to this device that are not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
CAUTION
Make sure the airflow around the front, and back of the device is not restricted.
CAUTION
Never leave tools inside the chassis.
CAUTION
To protect the serial port from damage, keep the cover on the port when not in use.
CAUTION
Do not install the device in an environment where the operating ambient temperature might exceed 45°C (113°F).

ESD precautions

DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megaohm resistor.
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05 21