4.
Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 36 Positioning the device in the rack
1.
Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the extensions
Complete the following steps to attach the rear brackets to the extensions. There are short, medium, and long rear brackets that you can
use for this step. Choose the correct bracket for the depth of your rack.
1.
Select the proper length rear bracket for your rack depth.
2.
Slide the right rear bracket onto the right extension, as shown in
The short rear brackets are shown. Use the first and third vertical pairs of holes for the screws.
Refer to
Figure 38
3.
Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4.
Repeat
Step 2
and
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
for the positioning of the medium or long brackets and screws.
Step 3
to attach the left rear bracket to the left extension.
2.
Retainer nuts, 10-32
Figure
37.
Mounting the Device
Flush-front mounting the device in the rack
59