FIGURE 21 Mounting a compact device under a fixed surface with long brackets (ICX7000-C12-RMK)
2.
Drill two holes under the fixed surface or desk where you want to mount the device.
3.
Hammer the mounting anchors into the two holes.
4.
With the bottom panel of the device facing down, use the #2 Phillips screwdriver to secure the two mounting screws into the
mounting anchors.
Mounting the compact device directly on a wall
Use the following items to wall mount the device directly to a wall:
•
#2 Phillips screwdriver
•
Hammer
•
Drill
•
Wall mount anchors
•
Wall mount screws
•
Wall Mount Holes Location template
•
Tape
NOTE
When mounting the device on a wall, mount the device with the port side down.
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
Mounting the Device
Mounting the compact device directly on a wall
39