Attaching The Bracket Extensions To The Device - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 34 Attaching the front brackets
1. Brocade device
2. Front brackets
3. Screws, 8-32 x 5/16-in., flathead Phillips

Attaching the bracket extensions to the device

Complete the following steps to attach the extension brackets to the device.
1. Position the right bracket extension along the side of the device as shown in
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket extension and then into the holes on
the side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat step 1 and step 2 to attach the left bracket extension to the left side of the device.
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
Flush-front mounting the device in the rack
Figure 35.
Mounting the Device
57