Attaching The Rear Brackets To The Bracket Extensions At The Front Of The Device - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb (29 cm-kg).
FIGURE 42 Positioning the device in the rack
1. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching the rear brackets to the bracket extensions at the front of the
device
Complete the following steps to attach the rear brackets to the bracket extensions. There are short, medium, and long front brackets that
you can use for this step.
1. Select the proper length rear bracket for your rack depth.
2. Slide the right rear bracket onto the right extension, as shown in
The short rear brackets are shown. Use the first and third vertical pairs of holes for the screws.
Refer to Figure 44
3. Attach the brackets using four 6-32 x 1/4-in. panhead screws.
4. Repeat Step 2 and
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05
for the positioning of the medium or long brackets and screws.
Step 3 to attach the left rear bracket to the left extension.
Flush-rear (recessed) mounting the device in the rack
2. Retainer nuts, 10-32
Figure 43.
Mounting the Device
65