Installing The Device In The Rack - Ruckus Wireless ICX 7150-C12P Hardware Installation Manual

Mounting the Device
Flush-rear (recessed) mounting the device in the rack
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 41 Attaching the bracket extensions to the device
1. Bracket extensions

Installing the device in the rack

Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
the rack.
2. Attach the right front bracket to the right rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
3. Attach the left front bracket to the left rear rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
64
Figure 42, providing temporary support under the device until the rail kit is secured to
2. Screws, 8-32 x 5/16-in., flathead Phillips
Ruckus ICX 7150 Switch Hardware Installation Guide
Part Number: 53-1004928-05